Stand for bird feeder - gray

Stand for our bird feeders / bird baths with stainless tube

material: gray lacquered concrete
30 x 30 x 5 cm
10 kg

The delivery includes the stand and a threaded rod.

The threaded rod is screwed into a socket in the concrete base, then the stainless steel rod of the birdhouse is attached.
When ordering a birdhouse and the stand at the same time, we add a threaded hole with an Allen screw on the side for better fastening and cut the rod straight off at the bottom.
The rod length is reduced by approx. 5 cm to a length of 1.45 m.

Please attend: The rod is normally inserted 15-20 cm into the ground. So the total height is smaller. With the stand the height becomes approximate 5cm higher.
If you want an lower height or/and a bottom rod with right-angled end (for using with this base), we can reduce the lenght of the rod.
Write in the message box during the order process: "shorten the rod bar by ... cm (or ") OR total height from ground till roof: ... cm (or ") ".

For our larger bird houses and bird baths, especially or if they are exposed to stronger wind, we recommend our feet measuring 40 x 40 cm. You can find our larger versions here